Conquest Map Help

[AssassinChao]

ok im currently thinking about putting a map of mine (once i finish it) in the Conquest Forgeoff... BUT i need to no something... is it considered a conquest map if it has 1 path that branches out and then comes back at the end of the line?

example:

please excuse the sloppiness of the picture... i made it in about 30 seconds... now the boxes indicate the spawn area and the two lines both start at the spawn but the branch off they r in the same room but they are leading to different territories and u can not travel from one line to the other unless u r at the end of one... i hope this all makes sense and plz help :)

[Nemihara]

You can only have one path going from each base to base. If there are any other ways to get around an occupying force, it's not conquest.

[AssassinChao]

hmmm ok... well this could put a hole in my map... >_< i was thinking that it would lead from the spawn point to the big room and... wait could i make it so that theres only 1 way to get back to the other side? like... i have a pit for a room and u go down the sides of the pit but theres a few territories on the way down and then theres one in the middle of the pit and then it goes back up the other side the same way? would that still be considered conquest?

[Vicious Vice]

I got bored and decided to draw out my 3 favorite conquest maps so you can get a clue of what the basics are and how they have been changed.



X = Spawns
Arrows = Direction of Movement
#'s = Teleporters/TeleBoxes
Flag = Center Territory

[Conkerkid11]

Don't know if this is right or not, but I think it has to be symmetrical for it to be in the contest. Just sayin' make sure it's Symmetrical.